材料科学
立方氧化锆
复合材料
表面粗糙度
表面光洁度
激光器
光学
作者
O. F. Biswas,A. Sen,Golam Kibria,Biswanath Doloi,B. Bhattacharyya
出处
期刊:Lecture notes in mechanical engineering
日期:2020-01-01
卷期号:: 91-97
标识
DOI:10.1007/978-981-15-1307-7_10
摘要
In the present days, the requirement of micro-machining has seen a rapid growth for the fabrication of precision machining of complex parts in automobile, shipbuilding, aerospace, electronics, medical industries, etc. Surface finish of these types of components is one of the most important criteria for fabricating better quality and to avoid failure caused by surface defects. The paper addresses the experimental investigation for the variation of surface roughness of micro-channel milling on flat zirconia (ZrO2) ceramics by using a pulsed fiber laser system. In this work, considered parameters are laser power, pulse frequency, laser scan speed, and the number of scan while responses considered are surface roughness parameters, i.e., Ra and Rz. The experimental results show that aforesaid factors revealed huge influences on surface finish criteria on machined micro-channel on zirconia ceramics.
科研通智能强力驱动
Strongly Powered by AbleSci AI