Novel study on improvement of plastics properties by blending of waste micro plastics into ABS plastics

Occupancy of waste micro plastic particles in the beach sand is found hazardous sea livings as well as creates the environmental issues. Many research attempts have been made to short out them. This investigation focuses on utilizing such micro plastic to produce cost effective ABS plasticproducts including toys manufacturing. The screened out micro plastic particles were chemically refined to obtain the pro form of Polypropylene (PP) and Polystyrene (PS) and then they used (10 wt%, 15 wt%, 20 wt%and 25 wt%) with raw ABS plastic and prepared billets by injection moulding. The moulding parameters like melting temperature (230 °C, 240 °C, 250 °C and 260 °C), injection pressure (1300 bar, 1400 bar, 1500 bar and 1600 bar) and injection time (0.4s, 0.8s, 1.2s and 1.6s) to maximize the Impact, tensile and flexural strengths of proposed plastic with Taguchi method. The results reveal that 25% micro plastic reinforced specimen prepared at 250 °C, 1400 bar and 1.6s, is outperformed.