Validation of the Mechanical Behavior of an Aeronautical Fixing Turret Produced by a Design for Additive Manufacturing (DfAM)

The design of parts in such critical sectors as the manufacturing of aeronautical parts is awaiting a paradigm shift due to the introduction of additive manufacturing technologies. The manufacture of parts designed by means of the design-oriented additive manufacturing methodology (DfAM) has acquired great relevance in recent years. One of the major gaps in the application of these technologies is the lack of studies on the mechanical behavior of parts manufactured using this methodology. This paper focuses on the manufacture of a turret for the clamping of parts for the aeronautical industry. The design of the lightened turret by means of geometry optimization, the manufacture of the turret in polylactic acid (PLA) and 5XXX series aluminum alloy by means of Wire Arc Additive Manufacturing (WAAM) technology and the analysis by means of finite element analysis (FEA) with its validation by means of a tensile test are presented. The behavior of the part manufactured with both materials is compared. The conclusion allows to establish which are the limitations of the part manufactured in PLA for its orientation to the final application, whose advantages are its lower weight and cost. This paper is novel as it presents a holistic view that covers the process in an integrated way from the design and manufacture to the behaviour of the component in use.