材料科学
聚二甲基硅氧烷
膜
阳极
化学工程
纳米技术
电解
碳氢化合物
自组装
软化
电极
弹性体
离子交换
电解水
膜电极组件
渗透(战争)
Nafion公司
制作
聚合物
耐久性
离子
微加工
介观物理学
水运
复合材料
质子交换膜燃料电池
流体学
中性面
粘附
含氟聚合物
作者
Tai The Mai,Seongmin Cho,Sungjun Kim,Segeun Jang
出处
期刊:Small
[Wiley]
日期:2026-09-16
卷期号:: e75759-e75759
摘要
ABSTRACT The membrane–electrode interface critically governs the performance and durability of anion exchange membrane (AEM) water electrolysis, yet engineering these interfaces in pre‐formed hydrocarbon AEMs remains challenging due to their high glass‐transition temperatures and thermally degradable quaternary‐ammonium cations. Here, we report a dual‐side patterning strategy enabled by localized solvent‐induced surface softening combined with plasma‐treated, gas‐permeable polydimethylsiloxane molds, allowing capillary‐driven pattern transfer without additional external pressure. Pillar (5 µm) and prism (10 and 20 µm pitch) features are uniformly replicated on both surfaces of a representative pre‐formed hydrocarbon AEM while preserving bulk membrane properties. Decoupled cathode‐, anode‐, and dual‐side patterning analysis reveals that both interfaces contribute, with the anode dominating and dual‐side patterning yielding a 12.6% synergistic enhancement (4.65 vs. 4.13 A cm −2 at 2.0 V, 1.0 M KOH); under electrolyte‐deficient conditions (1.0 mM KOH), this enhancement is amplified to 31%, supported by concentration‐dependent double‐layer capacitance analysis. The three‐dimensional interlocked architecture also strengthens interfacial adhesion and, under dynamic load cycling (200 cycles, 400 h), suppresses catalyst‐layer detachment relative to the flat reference. These findings establish dual‐side membrane patterning as a structural route to enhance both performance and interfacial robustness in AEM water electrolysis.
科研通智能强力驱动
Strongly Powered by AbleSci AI