控制理论(社会学)
超调(微波通信)
甩负荷
PID控制器
液压蓄能器
模型预测控制
控制器(灌溉)
计算机科学
挖掘机
史密斯预测器
能量(信号处理)
扭矩
自适应控制
流量控制阀
阀体孔板
上升时间
瞬态(计算机编程)
控制工程
常量(计算机编程)
流量(数学)
电子速度控制
工程类
瞬态响应
安全阀
控制系统
响应时间
沉降时间
管道(软件)
惯性
调压井
比例控制
电力负荷
鲁棒控制
作者
Shubhyanshu Singh,Ajit Kumar,Khac Duc Do
标识
DOI:10.1177/09576509261417453
摘要
Hydraulic excavators are widely used in the construction and mining industries. However, they operate inefficiently because they dissipate a considerable amount of energy through their relief valves during cyclic operation. To address this, the article proposes a novel energy regenerative setup, which is an accumulator-assisted valve-controlled hydromotor drive system. This system captures the waste energy in the accumulators and later uses it to drive the hydromotor. The hydromotor achieves the demand speed under varying step-load conditions by adjusting the orifice area of the proportional flow control valve present at its inlet using two different control strategies: a PID controller and an Adaptive Model Predictive Controller (AMPC). A mathematical model of the proposed system is developed in MATLAB/Simulink®, and Russell’s error method and uncertainty analysis are performed to validate the simulation results against experimental data. The tests were conducted at demand speeds of 400, 600, 800, and 1000 rpm. For a demand speed of 1000 rpm and a load of 3 Nm on the hydromotor, the results show that AMPC reduces the rise time by 19.6%, overshoot by 45%, and steady-state error by 46%. Even at higher loads (10 Nm–20 Nm), AMPC maintains lower overshoot (up to 66% reduction) and steady-state error. The analysis reveals that AMPC provides better disturbance rejection and tighter speed regulation than the PID controller. Additionally, this article examines the effect of system parameters on the speed response and finds that the load torque primarily influences the rise time and steady-state error. At the same time, the runtime is influenced mainly by the initial fluid volume in the charged accumulator. Furthermore, the sensitivity analysis suggests that optimal performance can be achieved with a high initial pressure in the charged accumulator, a high initial fluid volume in the charged accumulator, low load torque, and low demand speed.
科研通智能强力驱动
Strongly Powered by AbleSci AI