Simultaneous Conductivity and Viscosity Measurements as a Technique To Track Emulsion Inversion by the Phase-Inversion-Temperature Method

Two kinds of transitions can occur when an emulsified water-oil-ethoxylated nonionic surfactant system is cooled under constant stirring. At a water-oil ratio close to unity, a transitional inversion takes place from a water-in-oil (W/O) to an oil-in-water (O/W) morphology according to the so-called phase-inversion-temperature method. At a high water content, a multiple w/O/W emulsion changes to a simple O/W emulsion. The continuous monitoring of both the emulsion conductivity and viscosity allows the identification of several phenomena that take place during the temperature decrease. In all cases, a viscosity maximum is found on each side of the three-phase behavior temperature interval and correlates with the attainment of extremely fine emulsions, where the best compromise between a low-tension and a not-too-unstable emulsion is reached. The studied system contains Polysorbate 85, a light alkane cut oil, and a sodium chloride brine. All transitions are interpreted in the framework of the formulation-composition bidimensional map.