Thermal Conductivity of AlSi10MnMg Alloy in Relation to Casting Technology and Heat Treatment Method

Nowadays, with the development of electromobility, the requirements not only for the mechanical properties but also for the thermal conductivity of castings are increasing. This paper investigates the influence of casting and heat treatment technology on the thermal diffusivity and thermal conductivity of an AlSi10MnMg alloy. The thermal diffusivity was monitored as a function of temperature in the range of 50–300 °C for the material cast by high-pressure die casting (HPDC) and also by gravity sand casting (GSC) and gravity die casting (GDC). This study also investigated the effect of the T5 heat treatment temperature (artificial ageing without prior solution treatment—HT200, HT300, and HT400) on the thermal conductivity of the material cast by different technologies. Experiments confirmed that the thermal diffusivity or thermal conductivity of the alloy depends on the casting technology. The slower the cooling rate of the casting, the higher the thermal conductivity value. For the alloy in the as-cast condition, the thermal conductivity at 50 °C is in the range of about 125 to 138 [W·m−1·K−1]. Regardless of the casting method, the thermal conductivity tends to increase with temperature (50–300 °C). Furthermore, a positive effect of heat treatment without prior solution treatment (HT200, HT300, and HT400) on the thermal conductivity was demonstrated. Regardless of the casting method of the samples, the thermal conductivity also increases with increasing heat treatment temperature. The results further showed that when artificial ageing is performed in industrial practice on castings to increase mechanical properties in the temperature range of 160–230 °C, this heat treatment has a positive effect on thermal conductivity.