Plastic deformation behavior of Mg–8Li dual phase alloy during multi-directional compression

The Mg–8Li dual phase alloy was deformed by multi-directional compression with different passes. Microstructure evolution of deformed Mg–8Li alloy was analyzed by electron backscatter diffraction. X-ray diffraction profile was used to calculate the dislocation density in α-Mg and β-Li phase to reveal the quantitively change trend under different compression passes. The mechanical properties were assessed through tensile and compressive tests. The Mg–8Li alloy exhibited optimal mechanical properties when compressed with 12 passes (sample 12MDC), with a compression yield strength of 183.1 MPa and a tensile yield strength of 124.2 MPa. The improved mechanical properties in sample 12MDC were attributed to an increase in {10 1‾ 2} twin and {101‾ 3}-{101‾ 2} double twin boundaries, along with the presence of sub-grain boundaries and a reduced grain size in the α-Mg phase. Additionally, the inconsistent results between microhardness and dislocation density calculation manifests the uneven distribution of dislocations in β-Li phase. Broken α-Mg phase brings more phase interface to relieve the strain in β-Li phase, which results to a decreased dislocation density in sample 12MDC (1.19 × 1011/m2). Results show that weaken tension-compression yield asymmetry and more even distribution of dislocation in both phases could be achieved when the compression passes increases to 12.