Stick slip vibration seriously affects the life of drill string system,prolongs the drilling cycle,and endangers the safety of staff.In order to solve the problem of stick slip vibration caused by linear torque load and friction load in drilling engineering,the suppression law of stick slip vibration was analyzed from the influencing parameters.Firstly,based on the two-degree-of-freedom(TDOF)lumped mass model of drill string system,considering the interaction between bit and formation,the kinematic differential equation of drill string system was built.Then,based on the kinematic differential equation,and the Simulink calculation block diagram,the influences of torque,rotary speed,bit friction torque and stiffness coefficient on the stick slip vibration of drill string were discussed in detail.Finally,a test platform was designed to test the influences of rotary speed,friction resistance between drill string and sidewall(bit torque),and drill string stiffness coefficient(drill string length)on stick slip vibration under the condition that other parameters remain unchanged,and further verify the correctness of theoretical research and computer simulation.The study results show that the rotary speed,friction resistance between drill string and sidewall(bit torque)and stiffness coefficient of drill string(drill string length)are the main influencing factors of stick slip vibration.Therefore,increasing the rotation speed of rotary table of top drive,increasing the stiffness coefficient of drill string and reducing the friction torque of bit can suppress the stick slip vibration.The study results have certain reference significance for suppressing the stick slip vibration of drill string.