发射机
光束传播法
时域有限差分法
功率分配器和定向耦合器
光学
波导管
功率(物理)
多模光纤
干扰(通信)
最大功率转移定理
材料科学
物理
光电子学
电子工程
计算机科学
电信
工程类
光纤
量子力学
频道(广播)
折射率
作者
Salman Khateeb,Netanel Katash,Dror Malka
出处
期刊:Applied sciences
[Multidisciplinary Digital Publishing Institute]
日期:2022-06-24
卷期号:12 (13): 6444-6444
被引量:23
摘要
Photonic transmitters that operate with a high data transfer rate (over 150 Gb/s) at the O-band range (1260–1360 nm) require at least 100 milliwatts of power to overcome the power losses that are caused by using high-speed modulators. A laser with higher power can probably handle this requirement; however, for the transmitter system, this solution can be problematic due to the nonlinear effects that can happen, which may lead to high noise in the transmitter system. Thus, to solve this issue, we propose a new design of a 2 × 1 multimode interference (MMI) power combiner using silicon nitride (SiN) slot waveguide structures. The MMI power combiner and the SiN slot waveguide structures were optimized using the full-vectorial beam propagation method (FV-BPM) and the finite difference time domain (FDTD) method. After combining two sources, high efficiency was obtained of 94.8–97.6% from the total power after a short coupling length of 109.81 µm over the O-band range with a low back reflection of 44.94 dB. Thus, the proposed device can be very useful for combining two O-band sources to gain a higher power level, which can be utilized to improve performances in transmitter systems.
科研通智能强力驱动
Strongly Powered by AbleSci AI