Electrochemical removal of ethylene glycol monobutyl ether in aviation industry wastewater using a porous Ti4O7/Ti electrode

Titanium alloy chemical milling wastewater contains a significant amount of ethylene glycol monobutyl ether (EGBE), which is toxic and difficult to be degraded by microorganisms, and the emission will lead to severe environmental pollution. To solve this problem, the electrocatalytic oxidation method was employed to remove EGBE in the wastewater, in which a porous Ti 4 O 7 /Ti electrode were prepared and employed as the anode, while stainless steel acted as the cathode. The effects of current density, interelectrode distance, and stirring mode on the COD removal rate were also investigated. Results show that the COD of the wastewater significantly decreases from 12410 to 15 mg·L -1 after 16 hours of electrolysis at 10 mA·cm -2 and electrode spacing of 1.0 cm as well as aeration stirring at 100 mL·min -1 . Moreover, pilot-plant scale testing reveals that the COD decreasing from 11980 to 183 mg·L -1 after 24 hours of electrolysis. Consequently, the utilization of porous Ti 4 O 7 /Ti electrode as anode in the electrocatalytic oxidation method presents significant potential in removal of EGBE in aviation industry wastewater.