材料科学
复合材料
胶粘剂
表面粗糙度
微观结构
抗剪强度(土壤)
极限抗拉强度
表面光洁度
粘接
激光器
合金
纤维
铝
激光扫描
光学
图层(电子)
土壤水分
土壤科学
物理
环境科学
作者
Huan Wang,Seong Cheol Woo,Chung-Ki Sim,Seong-Kyun Cheong,Joohan Kim
标识
DOI:10.7736/jkspe.022.063
摘要
The adhesive bonding technology of carbon fiber reinforced plastics (CFRP) and aluminum alloys, is one of the lightweight joining technologies for automobiles. The strength and properties of the bonded joint, depend on the surface of the bonded part that the adhesive touches. Thus, proper surface treatment is one of the most important steps in the bonding process. The laser surface treatment of carbon fiber composites is a new form of green and environmental surface treatment technology, which can effectively clean coatings and pollutants on the surface of materials. It is also possible to improve the bonding shear strength, by changing the microstructure and roughness of the material surface through laser micro texture processing, to form a mechanically interlocked structure. In this study, a pulsed laser was used to treat the surface of CFRP. By changing the scanning line spacing during laser micro texturing, the effect of laser micro texturing on the surface morphology of CFRP and the strength of aluminum alloy bonded joints was investigated. Results show that in the laser micro texturing process, when the scanning line spacing was 0.3 mm, the maximum tensile shear strength was 14.5 MPa, approximately 200% higher than that without laser treatment.
科研通智能强力驱动
Strongly Powered by AbleSci AI