Lignin-incorporated cellulose-derived composite materials have attracted growing research interest owing to their excellent eco-friendliness, cost-effectiveness, and biocompatibility. Herein, multifunctional fluorescent composite films were successfully fabricated via a facile strategy without additional chemical additives, simply by integrating different contents of lignin into a cellulose acetate (CA) matrix. The resultant composite films exhibit outstanding UV-shielding performance, and can be applied for the fluorescent sensing of Fe 3 + ions as well as dual-mode recognition of benzylamine, showing great potential for smart packaging applications. The detection limit was calculated using 3σ/slope method and was found to be 0.664 ppm for Fe 3+ ions and 1.245 ppb for benzylamine. A series of systematic characterizations, including UV–vis, FTIR, fluorescence spectroscopy, XRD, XPS, EDS, and elemental mapping, were employed to verify the structure and properties of the prepared films. Mechanical tests demonstrated that the tensile strength of the composite films gradually increases as the lignin dosage rises from 25 mg to 75 mg in 5 g CA/DMF solution. However, further increasing the lignin content to 100 mg leads to excessive lignin aggregation, which causes a decline in mechanical strength. This work provides a novel insight into the design and fabrication of high-performance lignocellulose-based composite films for light regulation, chemical sensing, and active smart packaging applications.