Experimental investigation on shear strength deterioration at the interface between different rock types under cyclic loading

The shear strength deterioration of bedding planes between different rock types induced by cyclic loading is vital to reasonably evaluate the stability of soft and hard interbedded bedding rock slopes under earthquake; however, rare work has been devoted to this subject due to lack of attention. In this study, experimental investigations on shear strength weakening of discontinuities with different joint wall material (DDJM) under cyclic loading were conducted by taking the interface between siltstone and mudstone in the Shaba slope of Yunnan Province, China as research objects. A total of 99 pairs of similar material samples of DDJM (81 pairs) and discontinuities with identical joint wall material (DIJM) (18 pairs) were fabricated by inserting plates, engraved with typical surface morphology obtained by performing three-dimensional laser scanning on natural DDJMs sampled from field, into mold boxes. Cyclic shear tests were conducted on these samples to study their shear strength changes with the cyclic number considering the effects of normal stress, joint surface morphology, shear displacement amplitude and shear rate. The results indicate that the shear stress vs. shear displacement curves under each shear cycle and the peak shear strength vs. cyclic number curves of the studied DDJMs are between those of DIJMs with siltstone and mudstone, while closer to those of DIJMs with mudstone. The peak shear strengths of DDJMs exhibit an initial rapid decline followed by a gradual decrease with the cyclic number and the decrease rate varies from 6% to 55.9% for samples with varied surface morphology under different testing conditions. The normal stress, joint surface morphology, shear displacement amplitude and shear rate collectively influence the shear strength deterioration of DDJM under cyclic shear loading, with the degree of influence being greater for larger normal stress, rougher surface morphology, larger shear displacement amplitude and faster shear rate.