膜
结垢
聚酰胺
微尺度化学
材料科学
表面粗糙度
表面光洁度
化学工程
焊剂(冶金)
反渗透
界面聚合
薄膜复合膜
膜污染
复合材料
化学
聚合物
单体
冶金
数学教育
生物化学
工程类
数学
作者
Zhiwei Jiang,Santanu Karan,Andrew Guy Livingston
标识
DOI:10.1021/acs.iecr.9b04798
摘要
The surface of thin-film composite membranes used for reverse osmosis appears to be rough, known as a peak–valley morphology, and this is believed to cause more severe fouling than would occur for a smooth surface. In this study, polyamide nanofilms were made by interfacial polymerization on a sacrificial layer or at a free aqueous/organic interface, manipulating the surface from ultrasmooth (roughness ca. 0.2 nm) to crumpled (roughness ca. 80 nm) morphology. This approach enables the fabrication of morphologically similar polyamide nanofilms on different support membranes, and the control of their initial flux. Membranes with higher initial flux are more severely fouled while their surface roughness (either smooth or rough) is held constant. Moreover, when they are provided with the same initial flux, smooth and rough membranes showed insignificant differences in flux decline upon fouling. This teaches that it is the initial flux, rather than the surface roughness, which is the dominating factor influencing membrane fouling.
科研通智能强力驱动
Strongly Powered by AbleSci AI