Analysis of operation of new construction of the frictional joint with the resistance wedge / Analiza pracy nowej konstrukcji złącza ciernego z klinem oporowym

Frictional joint is the basic part of the friction props and yielding steel frames of dog headings. It constitutes a constructional connection and have decisive influence on the basic operational parameters of the steel frames and props, i.e. their loading capacity and yielding capacity. Currently applied constructions of frictional joints characterize with low loading capacity and unstable operation. In order to improve their operational parameters a new constructional solution of frictional joint, consisting on the application of resistance wedge assembled between the cooperating sections, was developed. Application of the resistance wedge caused an increase of resistances to motion in the frictional joint, what influenced on the increase of its loading capacity and on the increase of values of axial forces in the bolts of stirrups. In the paper results of stand tests of frictional joints with the resistance wedge, subjected to the static axial compression and impact of freely falling mass, were presented. In order to determine the influence of the resistance wedge on the operational parameters of the frictional joint, obtained results were compared with the results of studies of the frictional joints without the resistance wedge. On the basis of stand tests a physical and mathematical models of the frictional joint with the resistance wedge, were developed, and utilized to simulation analysis of its operation at impulse loading. On the basis of conducted tests and analysis one can state, that application of the resistance wedge influences on the enhancement of loading capacity, improves the state of loading the bolts in stirrups, and creates possibility of regulation of operational characteristics of the frictional joints