Preparation and Performance Verification of a Solid Slow-Release Carbon Source Material for Deep Nitrogen Removal in Urban Tailwater

Urban tailwater typically has a low carbon-to-nitrogen ratio and adding external carbon sources can effectively improve the denitrification performance of wastewater. However, it is difficult to determine the dosage of additional carbon sources, leading to insufficient or excessive addition. Therefore, it is necessary to prepare solid slow-release carbon source (SRC) materials to solve the difficulty in determining the dosage of carbon sources. This study selected two SRCs of slow-release carbon source 1 (SRC1) and slow-release carbon source 2 (SRC2), with good slow-release performance after static carbon release and batch experiments. The composition of SRC1 was: hydroxypropyl methylcellulose/disodium fumarate/polyhydroxy alkanoate (HPMC/DF/PHA) at a ratio of 3:2:4, with an Fe3O4 mass fraction of 3%. The composition of SRC2 was: HPMC/DF/PHA with a ratio of 1:1:1 and an Fe3O4 mass fraction of 3%. The fitted equations of carbon release curves of SRC1 and SRC2 were y = 61.91 + 7190.24e−0.37t and y = 47.92 + 8770.42e−0.43t, respectively. The surfaces of SRC1 and SRC2 had a loose and porous morphological structure, which could increase the specific surface area of materials and be more conducive to the adhesion and metabolism of microorganisms. The experimental nitrogen removal by denitrification with SRCs showed that when the initial total nitrogen concentration was 40.00 mg/L, the nitrate nitrogen (NO3−-N) concentrations of the SRC1 and SRC2 groups on the 10th day were 2.57 and 2.66 mg/L, respectively. On the 20th day, the NO3−-N concentrations of the SRC1 and SRC2 groups were 1.67 and 2.16 mg/L, respectively, corresponding to removal efficiencies of 95.83% and 94.60%, respectively. The experimental results indicated that SRCs had a good nitrogen removal effect. Developing these kinds of materials can provide a feasible way to overcome the difficulty in determining the dosage of carbon sources in the process of heterotrophic denitrification.