Mechanism of Lithium Metal Penetration through Inorganic Solid Electrolytes

作者
Tushar Swamy,Lukas Porz,Brian W. Sheldon,Daniel Rettenwander,Till Frömling,Harry Thaman,Stefan Berendts,Reinhard Uecker,W. Craig Carter,Yet‐Ming Chiang
出处
期刊:Meeting abstracts [Institute of Physics]
卷期号:MA2017-02 (4): 423-423 被引量:11
标识
DOI:10.1149/ma2017-02/4/423
摘要

Vast energy density improvements may be achieved in Li-ion rechargeable batteries with lithium metal anodes. However, lithium metal batteries containing liquid electrolytes have been unsuccessful thus far due to safety concerns associated with short circuits that occur when Li dendrites grow through the liquid electrolyte during the charging process. In contrast, thin film batteries using Li metal negative electrodes with an inorganic solid electrolyte (e.g., LiPON) appear to withstand dendrite penetration over extended cycling [1]. Recently, however, multiple research groups have reported and investigated cases where ceramic solid electrolytes paired with a Li metal anode experience a short circuit event [2,3]. The mechanism by which short circuit events occur in all-solid-state Li-ion batteries is unclear. Thus, in this project, the growth of lithium metal filled cracks through four types of solid electrolytes, glassy Li2S-P2S5 (LPS), β-Li3PS4­, polycrystalline and single crystal Li6La3ZrTaO12 (LLZTO), was studied using galvanostatic electrodeposition experiments coupled with in-situ and ex-situ microscopy. An electrochemomechanical model for growth of lithium-filled cracks was developed. For current densities up to 5 mA/cm2, only the as-fractured surface of glassy LPS exhibits lithium metal deposition at the surface alone, without penetration of the solid electrolyte. All other surfaces of the LPS and LLZTO samples studied had observable defects, the maximum initial sizes of which were characterized. Electrodeposition of lithium at these surfaces is accompanied by the filling, and then propagation, of lithium metal filled cracks. The experiments and model suggest that above a critical current density, the Li plating overpotentials, and corresponding mechanical stresses, reach values sufficiently large to propagate pre-existing surface defects. The results can be summarized, Figure 1, as a plot of the overpotential and corresponding mechanical stress necessary to extend a pre-existing sharp crack as a function of the crack length, for materials parameters suitable to LPS and LLZO. The prevailing failure mechanism in brittle solid electrolytes is Griffith-like, and differs from the amplification of kinetic perturbations at the metal interface that results in dendrite growth in liquid electrolytes. The results show that the shear-modulus criterion proposed by Monroe and Newman [4,5] for prevention of dendrites is not the determining factor for the high modulus, brittle inorganic electrolytes studied here. We suggest that stabilization of inorganic solid electrolyte interfaces against lithium metal penetration will require scrupulous attention to minimize interfacial defects. Acknowledgments Tushar Swamy and Lukas Porz contributed equally to this work. The authors gratefully acknowledge support from the US Department of Energy, Office of Basic Energy Science, through award number DE-SC0002633 (J. Vetrano, Program Manager). Brian W. Sheldon acknowledges additional support by the US Department of Energy, Office of Basic Energy Sciences under the award number DE-FG02-10ER46771. The authors also acknowledge use of the MIT Nanomechanical Technology Laboratory (A. Schwartzman, Manager). References 1. J. Li, C. Ma, M. Chi, C. Liang, and N. J. Dudney, Adv. Energy Mater., 5, 1401408–1401414 (2015) 2. Y. Suzuki et al., Solid State Ionics, 278, 172–176 (2015) 3. R. Sudo et al., Solid State Ionics, 262, 151–154 (2014) 4. C. Monroe and J. Newman, J. Electrochem. Soc., 151, A880–A886 (2004) 5. C. Monroe and J. Newman, J. Electrochem. Soc., 152, A396–A404 (2005) Figure 1
最长约 10秒,即可获得该文献文件

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
Jay完成签到,获得积分10
刚刚
刚刚
暮色将至发布了新的文献求助10
1秒前
1秒前
1秒前
ding的应助被mate采纳,获得10
2秒前
2秒前
3秒前
Endeavor发布了新的文献求助10
3秒前
自由不惜发布了新的文献求助10
3秒前
红莲墨生发布了新的文献求助10
4秒前
anna发布了新的文献求助50
4秒前
包容清炎发布了新的文献求助10
4秒前
研究啥发布了新的文献求助10
5秒前
amia发布了新的文献求助10
5秒前
可爱的函函的应助被Lu采纳,获得10
5秒前
7秒前
小二郎的应助被大方元风采纳,获得10
7秒前
8秒前
8秒前
G塔拉完成签到 ,获得积分10
9秒前
9秒前
海哥哥发布了新的文献求助10
9秒前
Az驳回了wia的应助
9秒前
10秒前
向分公司完成签到,获得积分20
10秒前
10秒前
10秒前
顺心含蕾发布了新的文献求助10
10秒前
12秒前
12秒前
man关注了科研通微信公众号
13秒前
13秒前
主打歌发布了新的文献求助10
14秒前
Owen的应助被XS_QI采纳,获得10
14秒前
14秒前
15秒前
hc发布了新的文献求助10
16秒前
长青发布了新的文献求助10
16秒前
MizzZeus完成签到,获得积分10
16秒前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
The World Atlas of Wine 9th edition 1000
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
八旗制度の研究 600
高分子基功能界面水蒸发材料与应用研究 500
外场增强的水汽发电研究 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8184267
求助须知:如何正确求助?哪些是违规求助? 9573323
关于积分的说明 21830790
捐赠科研通 7781314
什么是DOI,文献DOI怎么找? 3434307
关于科研通互助平台的介绍 2558389
邀请新用户注册赠送积分活动 2480817