等温淬火
材料科学
微观结构
冶金
铁氧体(磁铁)
粒度
合金
针状的
针状铁素体
体积分数
复合材料
贝氏体
奥氏体
作者
Priya Tiwari,A. Varshney
标识
DOI:10.1002/srin.202400090
摘要
In this work, the influence of part dimensions on the microstructure of low‐alloy steel during its austempering has been studied. 0.41C‐0.24Si‐0.63Mn‐0.93Cr steel of different diameters ranging from 5 to 16 mm has been austempered at 350 °C for 10 min. Despite similar austempering conditions, an increase in the size and fraction of acicular/polygonal ferrite has been noted with an increase in the diameter of the samples. From the experimental observations and analytical calculations based on multi‐dimensional transient heat transfer analysis, the cooling rate during austempering has been observed to increase with a decrease in the sample diameter. Variation in ferrite grain size and fraction is due to different cooling rates encountered by different sized specimens during austempering. Close agreement between the experimental and theoretically estimated ferrite grain size due to variation in cooling rate during austempering has been noted.
科研通智能强力驱动
Strongly Powered by AbleSci AI