Multi-objective optimization of FSW aviation-grade AA8090 alloy: an RSM-based design approach

Purpose This study aims to determine the effect of different friction stir welding (FSW) parameters on mechanical and metallurgical characteristics of aviation-grade AA8090 alloy joints. Design/methodology/approach Response surface methodology with central composite design is used to design experiments. The mechanical and microstructure characteristics of the weld joints have been studied through a standardized method, and the influence of threaded pins on the joint microstructure has also been assessed. Findings From a desirability strategy, the optimum parameters setting of the friction stir welding was the tool rotational speed (TRS) of 800, 1,100 and 1,400 rpm; tool traverse speed (TTS) of 20, 30 and 40 mm/min; and tilt angle 1°, 2° and 3° with different tool pin profiles, i.e. cylindrical threaded (CT), square threaded and triangular threaded (TT), for achieving the maximum tensile strength, yield strength (YTS) and % elongation as an output parameter. The TRS speed was the highest weld joint characteristics influencing parameter. Peak tensile strength (378 MPa), percentage elongation (10.1) and YTS (308 MPa) were observed for the optimized parametric value of TRS-1,400, TTS-40 mm/min and TA (3°) along with CT pin profile. Microstructure study of the welded surface was achieved by using scanning electron microscope of output parameters. When the tool rotation speed, tool transverse speed, tilt angle and tool profile are set to moderately optimal levels, a mixed mode of ductile and brittle fracture has been seen during the microstructure analysis of the welded joint. This has been aided by the material’s plastic deformation and the small cracks surrounding the weld zone. Originality/value From the reported literature, it has been observed that limited work has been reported on aviation-grade AA8090 alloys. Further thermal behavior of welded joints has also been observed in this experimental work.