Synthesis of H2TiO3–lithium adsorbent loaded on ceramic foams

Kaolin, talc powder and alumina were used as raw materials to prepare ceramic foams using a protein foaming agent via direct foaming. CH3COOLi and Ti(OC4H9)4 were employed as lithium and titanium sources, respectively to synthesize Li2TiO3 by the sol–gel process during which Li2TiO3 was loaded on ceramic foams to address the problem that powdery Li2TiO3 is difficult to be used in extracting lithium directly from the sea water and salt lake brine for engineering troubles. Hydrochloric acid was used to treat Li2TiO3 to obtain H2TiO3–lithium adsorbent. The results indicate that ceramic foams with a high open porosity are observed, and Li2TiO3 with particle size 80–100 nm is loaded on ceramic foams successfully. The Li+ drawn out ratio from Li2TiO3 reaches 50.2%, and the adsorptive capacity comes up to 21.0 mg g−1 after a treatment 24 h.