Induced and natural fracture interaction in tight-gas reservoirs

This paper investigates the interaction of an induced hydraulic fracture in the presence of a natural fracture and the subsequent propagation of this induced fracture. The developed, fully coupled finite element model integrates a wellbore, an induced hydraulic fracture, a natural fracture, and a reservoir that simulates interaction between the induced and natural fracture. The results of this study have shown that natural fractures can have a profound effect on induced fracture propagation. In most cases, the induced fracture crosses the natural fracture at high angles of approach and high differential stress. At low angles of approach and low differential stress, the induced fracture is more likely to be arrested and/or break out from the far-end side of the natural fracture. It has also been observed that the propagation of the induced fracture is stopped by a large natural fracture at a high angle of approach, when the injection rate remains low. At a low angle of approach, the induced fracture deviates and propagates along the natural fracture. Crossing of the natural fracture and/or arrest by the natural fracture is controlled by the shear strength of the natural fracture, natural fracture orientation, and the in situ stress state of the reservoir. In tight-gas reservoir development, the optimum well spacing and induced hydraulic fracture length are correlated. Therefore, fracturing design should be performed during the initial reservoir development planning phase along with the well spacing design to obtain an optimal depletion strategy. This model has a potential application in the design and optimisation of fracturing design in unconventional reservoirs including tight-gas reservoirs and enhanced geothermal systems.