Discovering the incorporation limits for wurtzite AlPyN1−y grown on GaN by metalorganic vapor phase epitaxy

We report on the growth of AlPN on GaN/sapphire templates by metalorganic vapor phase epitaxy using tertiarybutylphosphine (tBP) and NH3 as group-V precursors. P is easy to incorporate into the group-III lattice site, forming PAl anti-site defects and shrinking lattice constants that are even beyond AlN since Al is larger than P. We found that higher temperatures favor P incorporation on the N-sublattice, forming AlPyN1−y, while growth temperatures below 1000 °C result in dominant P incorporation on the Al-sublattice, forming PAl anisites. Similarly, larger NH3 flows stabilize GaN, leading to flat interfaces, but favor the formation of PAl. Furthermore, the P incorporation into AlPyN1−y is non-linear. At very low tBP flows, it initially increases to reach a maximum. Further increasing the tBP flow increases mostly the incorporation of P on the Al-sublattice, and the c-lattice constant decreases again. This leaves a small window of low V/III ratios below 5 and low P/N ratios of 1% or smaller, leading up to ∼4% P incorporation at typical growth temperatures of GaN. However, at such low V/III ratios, GaN is not stable even with N2 carrier gas and requires optimized switching sequences to minimize its decomposition and preserve flat interfaces. Eventually, a 10 nm coherent layer of AlP0.01N0.99 could be reproducibly grown on top of GaN channels with a smooth surface, an abrupt AlPN/GaN interface, and a two-dimensional electron gas with an electron mobility of ∼675 cm2/V s and a sheet carrier density of 1.5 × 1013 cm−2 at room temperature.