材料科学
泥浆
陶瓷
烧结
光致聚合物
抗弯强度
复合材料
流变学
过程变量
过程(计算)
聚合物
计算机科学
聚合
操作系统
作者
Dekun Kong,Anfu Guo,Hailong Wu,Xiaoyan Zhou,Xunjin Li,Peng Qu,Shaoqing Wang,Wenchao Han,Xiang Guo
摘要
Abstract Vat photopolymerization is an effective and economical method for preparing ceramic specimens with complex structures. However, the improper selection of process parameters during the preparation process limits the scope of its application. In this study, the most suitable shear rate was determined based on the solid content and rheological properties of the ceramic slurry. In addition, the specific printing‐process parameters were objectively selected, and the gray correlation method was used to determine the improved weight resolution coefficient through orthogonal experiments combined with the entropy weight method to select the most suitable printing parameters. Finally, the main debinding and sintering parameters that affect the heat treatment performance were considered, and multiple characterization methods were used to detect the specimens and study the impact of parameter changes on specimen performance. The experimental results show that when the laser power is 210 mW, the slice layer thickness is .04 mm, the scanning spacing is .05 mm, and the filling mode is XY, the green bodies have the best forming quality. When the sintering temperature is 1600°C, and the holding time is 4 h, the specimens have the best mechanical properties (the flexural strength reaches 114 MPa).
科研通智能强力驱动
Strongly Powered by AbleSci AI