The FEM Model of the Pump Made of Dielectric Electroactive Polymer Membrane

Dielectric electroactive polymers (DEAPs) undergo large deformations when subject to an electric field, which make them an attractive material for use in novel actuator systems. This article presents the possibility of using DEAPs to model an innovative pumping actuator structure. The model was used to map important object parameters at individual operating points of the modeled pump. The experimental work involved designing the membrane and testing its changes in elasticity under the influence of varying forces and voltage supplies. In the further part of the work, a finite element model (FEM) of a pumping device was implemented. In the new construction of the pump, pressure is generated by membrane deformation. This is due to electrostatic compressive force between two electrodes applied to the polymer surface and forces generated by permanent magnets. The results are presented graphically, confirming the compliance of the model with the measurements.