材料科学
电致变色
薄膜
无定形固体
基质(水族馆)
蓝宝石
透射率
表面粗糙度
光电子学
电致变色装置
分析化学(期刊)
激光器
光学
纳米技术
复合材料
电极
物理
地质学
物理化学
有机化学
化学
海洋学
色谱法
作者
Liubov S. Parshina,Oleg A. Novodvorsky
标识
DOI:10.1134/s0036023621080209
摘要
Abstract The laser synthesis method is used to fabricate amorphous dielectric WO3 films on fused silica and c-sapphire substrates at room temperature and thin LiCoO2 films (thickness, 10–60 nm) on c-sapphire and silicon substrates. The films are intended for use as the key components of thin-film all-solid-state electrochromic cells based on flexible polymer substrates. The optical and electrophysical properties and surface morphology of the films prepared at room temperature are studied in relation to the type of subtrate and oxygen pressure used during growth process. Variation of the oxygen pressure has a marginal effect on the surface roughness of the WO3 films, which is 4–5 nm. The type of substrate has almost no influence on the surface roughness of the LiCoO2 films, which on average is 35 nm. Increasing the oxygen pressure inside the vacuum chamber leads to the formation of the WO3 films with better light transmission characteristics in the entire considered range of 200–1000 nm. The transmittance of the LiCoO2 films increases from 30 to 70% in the investigated spectral range of 300–1000 nm. The low-temperature laser synthesis is used in fabricating a WO3-based solid state electrochromic cell. When a voltage of 2 V is applied, its transmittance in the spectral range of 300 to 900 nm decreases by 30% for 2 min.
科研通智能强力驱动
Strongly Powered by AbleSci AI