码头
结构工程
非线性系统
横截面
刚度
地震动
机械
梁(结构)
工程类
磁滞
剪切(地质)
计算机模拟
地震分析
失效模式及影响分析
数值分析
岩土工程
本构方程
地震荷载
地质学
运动方程
计算
有限元法
数学模型
剪切力
作者
Yongkui Wen,Xiaofei Zuo,Dexin Li,Mengfei Zheng
标识
DOI:10.1142/s0219455427500180
摘要
Continuous rigid-frame bridges (CRFBs) with tall and short piers have been extensively constructed in mountainous areas. The nonlinear seismic responses and failure mechanisms of CRFBs are more complex than those of conventional bridges. The fiber beam model is typically used to simulate the constitutive behavior of component sections at a high computational cost and imposes complex modeling and substantial computational demands during the nonlinear analysis of the entire bridge. In this study, a numerical model was developed to simulate effectively and accurately the nonlinear behavior of CRFBs using the generalized Bouc–Wen model, considering the strength degradation, stiffness degradation, and pinching effects. The plastic and degradation behaviors were regulated by the parameters of the Bouc–Wen model. Using a six-span CRFB with tall and short piers as an example, the longitudinal and transverse seismic responses and failure mechanisms of the piers of a CRFB under near-fault and far-field (FF) motions were analyzed. The numerical results indicated that the piers entered the yielding state in the order of increasing pier height under longitudinal excitation conditions. Different yielding sequences of the piers in the transverse direction were identified depending on the type of ground motion and the dynamic characteristics of the tall and short piers. The failure mechanisms were verified by comparing the curvature, moment, and shear force distributions of the tall and short piers. Significant effects of the high-other modes on the responses of the high-height piers were observed, particularly for the pier under FF ground motion in the transverse direction.
科研通智能强力驱动
Strongly Powered by AbleSci AI