Cu(II) assisted peroxymonosulfate for antibiotic resistant bacteria inactivation: A potential disinfection technology in swimming pool

Alternative disinfection technology to chlorination is required to control the risk of antibiotic resistance in swimming pools. In this study, copper ions (Cu(II)), which often exist in swimming pools as algicides, were used to activate peroxymonosulfate (PMS) for the inactivation of ampicillin-resistant E. coli. Cu(II) and PMS showed synergistic effects on E. coli inactivation in weak alkaline conditions, obtaining 3.4 log inactivation in 20 min with 10 μM Cu(II) and 100 μM PMS at pH 8.0. Quenching experiments indicated that radicals (i.e., OH and SO4−) were not the main disinfectors for E. coli inactivation. Based on the structure of Cu(II) and density functional theory calculations, the Cu(II)-PMS complex (Cu(H2O)5SO5) was recommended as the active species for E. coli inactivation. Under the experimental conditions, the PMS concentration had a greater influence on E. coli inactivation than the Cu(II) concentration, possibly because increasing PMS concentration accelerates ligand exchange reaction and facilitates active species generation. By forming hypohalous acids, halogen ions could improve the disinfection efficiency of Cu(II)/PMS. The addition of HCO3− concentration (from 0 to 1.0 mM) and humic acid (0.5 and 1.5 mg/l) did not significantly inhibit the E. coli inactivation. The feasibility of adding PMS to waters containing Cu(II) for the inactivation of antibiotic-resistant bacteria was validated in actual swimming pool waters, where 4.7 log inactivation of E. coli was achieved in 60 min.