Axial compressive behavior of cold-formed steel built-up box-shape columns with longitudinal stiffeners

This paper presents a study on the behavior of cold-formed steel built-up box-shape columns with longitudinal stiffeners (CFS-BCL) under axial compression. The specimens are fabricated using a pair of channel sections and lipped channel sections with longitudinal stiffeners, which are expected to enhance the local buckling resistance of the web. Sixteen specimens were prepared for compression tests, with varying lengths and screw arrangements. Prior to the tests, initial geometric imperfections of the specimens, material properties, and shearing-resistance behavior of the screw fasteners were measured. The results indicate that screw arrangements have a significant effect on simply supported specimens; reducing the screw spacing from 300 mm to 100 mm can increase load-bearing capacity by up to 11%. Finite element models were developed using ABAQUS and validated against test results. The parametric analysis revealed that screw arrangements had minimal impact on the local buckling capacity of specimens, with an increase in capacity of <8%. However, global buckling behavior was significantly affected by screw arrangements, resulting in an increase in capacity of up to 20% for slender columns. The test and analytical results were compared with the Direct Strength Method (DSM), and indicate that the DSM is conservative when the non-dimensional slenderness ratio λg and λl is higher than 1.2 and 1.4, respectively. The coefficients of the DSM were modified based on the test and simulation results, and its predictive accuracy was found to be highly increased.