带宽(计算)
钢丝绳
CMOS芯片
发射机
电气工程
收发机
电子工程
硅光子学
寄生提取
工程类
光子学
计算机科学
光电子学
电信
材料科学
频道(广播)
无线
作者
Arian Hashemi Talkhooncheh,Weiwei Zhang,Minwo Wang,David J. Thomson,Martin Ebert,Ke Li,Graham T. Reed,Azita Emami
出处
期刊:
日期:2022-02-20
被引量:10
标识
DOI:10.1109/isscc42614.2022.9731563
摘要
Data centers continue to require interconnects with higher bandwidth densities and energy efficiencies. Silicon photonics (SiP)-based solutions have gained interest for implementing low-cost and power efficient 100+Gb/s/A optical transceivers. While microring modulators (MRMs) have small footprints and high electro-optical bandwidth (EOBW), they suffer from an inherent tradeoff between bandwidth and optical phase efficiency, high sensitivity to process and temperature variations, and non-linear electro-optic characteristics [1 – 2]. Travelling-wave Mach-Zehnder Modulators (TW-MZMs) require power-hungry drivers to compensate microwave losses and occupy large areas on chip [3 – 4]. Metal-oxide-silicon-capacitor (MOSCAP)-based phase modulators can significantly scale the area and power of the optical transmitter (OTX) owing to their superior optical efficiency (voltage-length product at n phase shift of V π L < 1Vmm) and compact footprint (< 1mm) [5]. MOSCAP modulators, however, impose large capacitive parasitics (~3fF/μm), which could limit the electro-optical bandwidth (EOBW) significantly. State-of-the-art wireline transmitters cannot meet the requirements of MOSCAP modulators due to their 50Ω-terminated design and limited output voltage swing [6]. This paper presents a 3D-integrated 100Gb/s PAM-4 OTX with electronic pre-distortion (PD) and BW extension techniques to compensate for MOSCAP modulator BW limitations.
科研通智能强力驱动
Strongly Powered by AbleSci AI