材料科学
塞贝克系数
热电效应
热电发电机
热电材料
工程物理
发电
功率(物理)
光电子学
纳米技术
热导率
热力学
复合材料
物理
工程类
作者
Jinsuo Hu,Yuxin Sun,Hao Wu,Zhiyuan Yu,Jianbo Zhu,Fengkai Guo,Zihang Liu,Wei Hua Cai,Jiehe Sui
标识
DOI:10.1002/adfm.202418244
摘要
Abstract n‐Type Mg 3 (Sb, Bi) 2 shows great prospects in mid‐temperature power generation due to its extraordinary thermoelectric (TE) performance, low‐cost, and environment‐friendly attributes. However, its practical application is hindered by the slow progress of its p‐type counterpart. Herein, a high ZT of ≈0.9 at 773 K is achieved for p‐type Na 0.01 Mg 1.7 Zn 1 Yb 0.25 Sb 2 through manipulation of the electronic transport properties. Then thermal expansion matched barrier material Fe 75 Sb 25 is subtly obtained for Na 0.01 Mg 1.7 Zn 1 Yb 0.25 Sb 2 . The contact resistivity no longer increases significantly after aging for 72 hours at 673 K and tends to stabilize, remaining below ≈17 µΩ cm 2 after 168 hours. Paired with the high‐performance n‐type Mg 3 (Sb, Bi) 2 , the transient liquid phase bonding technique is adopted to connect the hot side of the all‐Mg 3 Sb 2 ‐based legs to electrode at low temperature, which enables service at high temperature. This all‐Mg 3 Sb 2 ‐based module displays a high efficiency of ≈8.3% at a temperature difference of ≈430 K and shows good thermal stability when the hot side temperature is maintained at 673 K. This work merits the great potential of the all‐Mg 3 Sb 2 ‐based device for heat recovery.
科研通智能强力驱动
Strongly Powered by AbleSci AI