A Microfluidic Flow Sensor Based on CuO Nws Enhanced Solid-Liquid Contact Electrification for Trapping Platelets on Collagen and Its Quantification

Platelet number plays an important role in several kinds of diseases such as leukemia, hepatitis C, diabetes, COVID-19, microbial infections, etc. These diseases can result in thrombocytopenia, a condition where patients suffer from reduced platelets, thus requiring the need to frequently monitor the platelet count. Currently existing techniques are complex, costly, and time consuming. The target diseases continue to evolve urging the need to develop rapid, facile point-of-care devices with high precision. In this regard, the current study is focused on the development of a platelet quantification technique based on trapping of platelets in a microfluidic channel adhered with collagen layer, and CuO NWs grown on Cu tube integrated on both the sides of the channel. This trapping of platelets results in a change in the triboelectric output performance from solid-liquid contact electrification due to change in flow rate of platelet content in the plasma. These changes in triboelectric output are enhanced by CuO NWs due to its high surface-area-to-volume ratio. The study of flow sensing by integrating the microfluidic device with solid-liquid contact electrification has been reported for the first time. The flow sensing signal was optimized by variation in viscosity of the flowing liquid, channel geometry, flow rate, and triboelectric voltage measuring methods. The platelet rich plasma (PRP) and platelet poor plasma (PPP) were prepared and mixed in different ratios to prepare the solutions with different concentration of platelets (0% - 100%). The calibration curve for platelet quantification has shown a variation of 9 V for change in platelet concentration from 0% to 100%. The proposed device exhibited a linear response with the variation in platelet counts. The obtained results prove its potential and feasibility as a point-of-care device.