Carbon dioxide and methane are two main gas causing greenhouse gas phenomena. They are also the main components of biogas (roughly 35-50% CO2 and 50-65% CH4), natural gas (roughly 70-95% CH4), and flue gas (mainly CO2). These resources are up-to-date modestly valorized. Natural gas is usually used for heat and electricity production. Biogas is usually upgraded for injection to natural gas grids. CO2 capture and utilization from flue gas is still very limited. On the other hand, both carbon dioxide and methane can be used as starting materials for synthetic gas (syngas, a mixture containing mainly CO and H2) using different reforming processes including steam reforming, dry reforming, partial oxidation and autothermal oxidation. Steam reforming is now deployed at industrial scale but its energetic balance needs still to be improved because of high steam/carbon ratio used during steam reforming process. Partial oxidation and autothermal oxidation are also efficient for methane conversion but they did not allow incorporating CO2 in the processes. Dry reforming of methane (DRM) appears as the most promising process because of the simultaneous consumption of CO2 and CH4 according to the following equation: CH4 + CO2 → 2CO + 2H2.The main challenge of DRM process relates to the deactivation of the catalyst. In fact, both CO2 and CH4 are stable molecules and need high temperature for breaking their chemical bonds. This process needs typically temperatures higher than 700°C at low pressure (close to atmosphere) to have exploitable kinetic. Under these conditions, metallic catalysts used for this process (i.e. nickel catalysts) are usually deactivated by the presence of side reactions such as Bououard reaction, reverse water-gas-shift reaction, methane cracking, coke deposition, as well as thermal sintering of support and metal particles. In this paper, we present our last research on DRM process using hydroxyapatite supported nickel and/or cobalt catalysts. Hydroxyapatite (HAP, Ca10(PO4)6(OH)2) has advantages to be thermally stable up to around 1100°C, to be not water sensitive, to have controlled acido-basicity from the adjustment of Ca/P ratio as well as high specific surface area. In the literature, this material is still less studied, in particular for reforming processes. The results obtained show that Ni/HAP and Ni-Co/HAP are very active and stable during long reaction time of around 300 hours. This high catalytic performance can be explained by the formation of nano Ni and/or Co particles, which are well distributed on HAP surface, the high basicity of HAP support and the strong metal-support interaction for resisting to thermal sintering. The characterization of used catalyst shows also very low carbon deposition rate. These results are very promising for the design of a performing catalyst for DRM process.