Emulsion polymerization of vinyl acetate. II

Abstract The emulsion polymerization of vinyl acetate was investigated at low ionic strengths and has quite unusual kinetics. The rate of polymerization is dependent on the initiator concentration to the first power and independent of soap concentration. In seeded polymerizations, the rate of polymerization depends on initiator to the 0.8 power, particle concentration to the 0.2 power, and monomer volume to 0.35 power. In all cases the rate of polymerization is almost independent of monomer concentration in the particles until 85–90% conversion. These results were rationalized by the following mechanism: (a) polymerization initiates in the aqueous phase because of the solubility of the monomer and is stabilized there by adsorption of ionic soap on the growing polymer molecule; (b) the growing polymer is swept up by a particle at a degree of polymerization (under our conditions) of about 50–200. Growth continues in the particle. This sweep‐up is activation‐controlled as both particle and polymer are charged. (c) Chain transfer to the acetyl group of monomer gives a new small radical which cyclizes to the water‐soluble butyrolactonyl radical, and reinitiates polymerization in the aqueous phase; (d) the main termination step is reaction of an uncharged butyrolactonyl radical with a growing aqueous polymer radical. A secondary reaction at low ionic strength is sweep‐up of an aqueous radical by a particle containing a radical. At high ionic strength, this is the major termination step. The unusual kinetic steps are justified by data from the literature. They are combined with the usual mechanisms operating for vinyl acetate polymerization and kinetic equations are derived and integrated. The integral equations were compared with the experimental data and shown to match it almost completely over the whole range of experimental variables.