Experimental modal analysis for the plate structures with roving inertial shaker method approach

In this article, a new roving inertial shaker method approach, using an inertial shaker, is presented to obtain a steel plate’s modal parameters with bolt connections on four sides. It aimed to emphasize the superiority of the proposed roving shaker approach over the classical, traditional hammer method on the plate-like structures. The frequency response functions (FRF), obtained from both methods, are investigated using the stabilization diagram, and the superiority of the roving shaker method is presented based on high stabilization and detecting more modes. The accelerometer’s position effect on experimental modal analysis (EMA) is investigated in the roving shaker method, which is performed using accelerometers in two different places, and obtained modal parameters are compared with experimental modal analysis validation methods. Accordingly, the results for the two separate locations are very close to each other. Finally, the experimental and numerical results are investigated according to the TEST/FEA correlation for the traditional roving hammer method and the roving shaker method. As a result, the roving shaker approach gives a better result according to the TEST/FEA correlation success than the roving hammer test. In conclusion, the high stabilization, high TEST/FEA correlation rate, and the number of modes show the roving shaker approach’s superiority.