2D MoS2 as an efficient protective layer for lithium metal anodes in high-performance Li–S batteries

Among the candidates to replace Li-ion batteries, Li–S cells are an attractive option as their energy density is about five times higher (~2,600 Wh kg−1). The success of Li–S cells depends in large part on the utilization of metallic Li as anode material. Metallic lithium, however, is prone to grow parasitic dendrites and is highly reactive to several electrolytes; moreover, Li–S cells with metallic Li are also susceptible to polysulfides dissolution. Here, we show that ~10-nm-thick two-dimensional (2D) MoS2 can act as a protective layer for Li-metal anodes, greatly improving the performances of Li–S batteries. In particular, we observe stable Li electrodeposition and the suppression of dendrite nucleation sites. The deposition and dissolution process of a symmetric MoS2-coated Li-metal cell operates at a current density of 10 mA cm−2 with low voltage hysteresis and a threefold improvement in cycle life compared with using bare Li-metal. In a Li–S full-cell configuration, using the MoS2-coated Li as anode and a 3D carbon nanotube–sulfur cathode, we obtain a specific energy density of ~589 Wh kg−1 and a Coulombic efficiency of ~98% for over 1,200 cycles at 0.5 C. Our approach could lead to the realization of high energy density and safe Li-metal-based batteries. An ~10-nm-thick MoS2 layer stabilizes lithium metal anodes and the composite can be used in full-cell Li–S batteries with enhanced performances.