TOPCon-based perovskite/silicon tandemsolar cells : interconnection and system optimization

作者
Mario Hanser
出处
期刊:Universitätsbibliothek Freiburg - FreiDok plus [University of Freiburg]
标识
DOI:10.6094/unifr/284290
摘要

Tandem solar cells are a promising technology to overcome the efficiency limitation of conventional silicon single junction solar cells. In particular, the combination of perovskite top solar cells with established silicon solar cells as bottom cell is studied with great interest worldwide. Thereby, the choice of the bottom cell is pivotal, as it contributes to the total energy output and influences the perovskite formation when used as substrate for the top cell processing. Although silicon heterojunction (SHJ) solar cells are commonly used in research, the presented work focuses on tunnel oxide passivating contacts (TOPCon) bottom cells, as this technology currently dominates industrial production. In this work, TOPCon bottom cells are integrated into perovskite/silicon tandem devices featuring an industrial random pyramids front side texture. Conformal coverage of the textured front side is achieved by depositing the perovskite absorber via a hybrid evaporation/spin-coating process, resulting in the so-called fully-textured solar cell design. The influence of the different lateral conductivity of SHJ- and TOPCon-contact layers on charge carrier diffusion out of the active solar cell area is investigated. Furthermore, an in-depth investigation of various TOPCon2 bottom cell architectures employing p-TOPCon as the hole contact and n-TOPCon as the electron contact is conducted to identify the optimal bottom cell design. In the scope of this thesis, this is a solar cell with a p-TOPCon rear emitter on a non-textured silicon wafer rear side. This combines the advantages of a better surface passivation quality of p-TOPCon on planar surfaces and the higher shunt resistivity of p-TOPCon compared to n-TOPCon. This research enabled the production of TOPCon2 bottom solar cells with remarkably high implied VOCs above 730mV, as well as the demonstration of the first fully-textured tandem solar cell incorporating a TOPCon2 bottom cell with an efficiency of 30.6%. Although ITO was used as the recombination layer for these solar cells to showcase the efficiency potential, indium is not an option for solar cell mass production on terawatt scale. Therefore, the integration of the indium-free alternatives ZTO and AZO is investigated. To this end, the sputter deposition of ZTO and ITO on TOPCon is analysed. Afterwards, the material properties of AZO, ITO and ZTO are compared and their tandem integration is investigated. A central findings of this study is, that TCOs can be sputtered at high power on TOPCon, which enables high throughput and industrial application. Furthermore, ZTO is identified as a promising indium-free recombination TCO which is sputtered in an industrially feasible process without a performance penalty compared to ITO. Polysilicon tunnel junctions consisting of a n-doped TOPCon layer and a second p-doped polysilicon layer on top are investigated as second option for an indium-free recombination junction. A systematic investigation of the process sequence and process parameters for the tunnel junction production provides a fundamental understanding of the process requirements. Subsequently, two process routes for the tunnel junction production are identified which, in addition to low contact resistivity and high substrate surface passivation quality, also enable lean process integration. However, the contact formation between HTL and the p-polysilicon layer of the tunnel junction is a major challenge. Despite systematic investigation of HTL materials, p-TOPCon surface treatments, and p-TOPCon layer properties across several single junction perovskite batches, this challenge could not be fully resolved. Further investigations should focus on a fundamental understanding of the HTL/p-TOPCon contact and comparison to the HTL/TCO contact formation. Finally, proof-of-concept solar cells incorporating a polysilicon tunnel junction are realized by incorporating a Ni/NiOx layer stack between the HTL and p- TOPCon to enhance contact formation. The presented solar cells are strongly limited by the optical transparency of the incorporated Ni/NiOx layer stack, as well as high contact resistivities. Incorporating doped NiOx layers is suggested for future investigations, as a higher doping concentration could eliminate the need for a metallic layer and reduce series resistance, thus resolving both limitations.

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
ganyanhui发布了新的文献求助10
刚刚
完美世界的应助被友好元槐采纳,获得10
刚刚
汉堡包的应助被可可采纳,获得10
刚刚
刚刚
小二郎的应助被卓尔不群金良采纳,获得10
1秒前
1秒前
充电宝的应助被chiyudawang采纳,获得10
1秒前
虚幻雪一发布了新的文献求助10
1秒前
桐桐的应助被lalala采纳,获得10
2秒前
蓝意发布了新的文献求助10
2秒前
2秒前
molihuakai的应助被彪壮的绮烟采纳,获得10
3秒前
Maestro_S的应助被张若虚采纳,获得10
3秒前
3秒前
落后夏之发布了新的文献求助10
4秒前
molihuakai的应助被嘟噜采纳,获得10
4秒前
4秒前
Cc发布了新的文献求助10
4秒前
LL完成签到,获得积分10
5秒前
5秒前
Akim的应助被ZND采纳,获得10
5秒前
洋芋大大王完成签到 ,获得积分10
5秒前
Hao发布了新的文献求助10
5秒前
6秒前
ganyanhui完成签到,获得积分10
6秒前
6秒前
6秒前
wanci的应助被单薄翠绿采纳,获得10
7秒前
7秒前
热心的荣轩完成签到,获得积分10
8秒前
Akim的应助被Xia采纳,获得10
8秒前
李健的应助被Xia采纳,获得10
8秒前
8秒前
小蘑菇的应助被Xia采纳,获得10
8秒前
CipherSage的应助被聪明的豌豆荚采纳,获得20
8秒前
厚朴大师发布了新的文献求助10
9秒前
9秒前
含糊的之味完成签到,获得积分10
9秒前
FashionBoy的应助被元宝采纳,获得10
9秒前
桐桐的应助被mary采纳,获得10
9秒前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
John McDowells Bildungstheorie 800
八旗制度の研究 600
plantTFDB 508
高分子基功能界面水蒸发材料与应用研究 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8178203
求助须知:如何正确求助?哪些是违规求助? 9568998
关于积分的说明 21802098
捐赠科研通 7773088
什么是DOI,文献DOI怎么找? 3432711
关于科研通互助平台的介绍 2556748
邀请新用户注册赠送积分活动 2478259