Reflective multi-layer metasurface based on half-wave plate structure for polarization control in the visible-near-infrared region

Abstract The precise control of the polarization of the electromagnetic field in the optical range is studied. A numerical simulation was performed, which corresponds to the optical devices operating in the 650–800 nm range and does not present any obstacles for fabrication. According to this, the three-layer system based on metasurfaces was developed, which operates as a half-wave plate consisting of a metal-dielectric-metal structure and takes very small dimensions, more than 3 times smaller than the observed wavelength. This half-wave plate is reflective and exhibits almost ideal behavior with a spectral width of about 10 nm within 735–745 nm. The losses are negligible, and the amplitude ratio of the directly reflected components in almost the entire studied spectrum exceeds 90%. With a spectrum of about 100 nm within 650–800 nm, it is 99%. Also, the system has an advantage characteristic of metasurfaces: regardless of the angle of the incident wave with the normal, it shows high efficiency, and even when the incident wave is below 45°, the polarization conversion ratio (PCR) remains greater than 80%. The system has optimal geometric dimensions, which works especially well, but even if the dimensions change (due to fabrication defects), its effectiveness does not weaken. The proposed system can become a very promising optical device and be used to control the state of electromagnetic waves in the optical range.