膜
接触角
材料科学
聚合
化学工程
润湿
高分子化学
水银孔隙仪
嫁接
丙烯酸
多孔性
X射线光电子能谱
表面改性
复合材料
化学
聚合物
多孔介质
共聚物
工程类
生物化学
作者
Li Zhu,Bao‐Ku Zhu,Li Xu,Yongxiang Feng,Fu Liu,You‐Yi Xu
标识
DOI:10.1016/j.apsusc.2007.01.004
摘要
Graft polymerization of acrylic acid (AA) onto porous polyethersulfone (PES) membrane surfaces was developed using corona discharge in atmospheric ambience as an activation process followed by polymerization of AA in aqueous solution. The effects of the corona parameters and graft polymerization conditions on grafting yield (GY) of AA were investigated. The grafting of AA on the PES membranes was confirmed by ATR-FTIR and X-ray photoelectron spectroscopy (XPS) analysis. Porosimetry measurements indicate the average pore diameters and porosities of the modified membranes decrease with the increase of the GY. The hydrophilicity and surface wetting properties of the original and modified membranes were evaluated by observing the dynamic changes of water contact angles. It is found that the grafting of AA occurs not only on the membrane surfaces, but also on the pore walls of the cells inside the membrane. The permeability experiments of protein solution reveal that the grafting of PAA endows the modified membranes with enhanced fluxes and anti-fouling properties. The optimized GY of AA is in the range of 150–200 μg/cm2. In addition, the tensile experiments show the corona discharge treatment with the power lower than 150 W yields little damage to the mechanical strength of the membranes.
科研通智能强力驱动
Strongly Powered by AbleSci AI