Experimental Study on the Thermal Stability of Aluminum Alloy 7075-T651 Structural Parts after Rolling Correction

The rolling correction process can eliminate machining distortions of aluminum alloy 7075-T651 structural parts. The thermal stability of the corrected structural parts under the action of temperature loading, especially the macroscopic shape stability, is key to ensure the safe service of mechanical equipment. In this study, different thermal loads were used to postprocess aluminum alloy 7075-T651 structural parts after rolling correction. The thermal stability of the rolled samples was analyzed by characterizing the microstructure and physical and mechanical properties. The results show no obvious change compared to rolling in the distortion of the parts after temperature treatments at 120 °C, 160 °C, 230 °C and 300 °C; the distortion changes were only 10.48%, 2.74%, 8.13% and 8.70%, respectively. The residual stresses in the rolling areas of the samples decreased by 35.58%, 26.08%, 75.97% and 83.13%, respectively. The microhardness also showed a decreasing trend. There was no obvious change after treatment at 120 °C, but the hardness decreased by approximately 5%, 23% and 56%, respectively, after treatments at other temperatures. However, the rolling stress relaxed under thermal stress. The microstructure change analysis shows that the material microstructure is mainly dominated by static reversion at lower thermal loads. With increasing thermal load, the samples are mainly affected by the static recrystallization effect, the microstructure is gradually blurred, and the hardness decreases significantly. In conclusion, although the residual stresses introduced by rolling would occur in different degrees of stress relaxation under the thermal load, the microstructure changes caused by thermal load did not significantly affect the macroscopic distortion of the samples, and the macroscopic shape of the structural parts after rolling correction had good thermal stability.