Arc Discharge Synthesis and Multistep Purification of Multiwall Carbon Nanotubes

This research work describes the cost-effective synthesis and purification of multiwall carbon nanotubes (MWCNTs). Synthesis of CNTs was carried out in distilled water between two electrodes using the electric arc discharge (EAD) method. EAD is a simple and straightforward route in which an electric arc is generated between graphite electrodes through DC power source to produce soot which contains MWCNTs along with impurities. The deposited soot containing MWCNTs was then chipped off and purified. In this case, multistep purification scheme was opted to remove unwanted impurities from produced MWCNTs. Purification route comprised thermal treatment, chemical treatment and a combination of both to yield pure MWCNTs. Thermal treatments were carried out in normal air and under controlled flow of oxygen at different temperatures whereas chemical treatment was performed using acidic solution. Thermo gravimetric analysis (TGA), field emission scanning electron microscopy (FE-SEM) and X-ray diffraction (XRD) were carried out before and after purification treatments to investigate the outcome of employed treatments. Results showed that the thermal or chemical treatment alone is not sufficient to remove impurities from soot. Moreover, the introduction of an oxide group through chemical treatment reduces the oxidization temperature of graphitic particles. It was found that the chemical treatment followed by thermal annealing under the controlled flow of oxygen is the most appropriate method for successful purification of MWCNTs synthesized via EAD method.