Calculation of Forces to the High Granularity Calorimeter Stainless Steel Absorber Plates in the CMS Magnetic Field

The general-purpose Compact Muon Solenoid (CMS) detector at the Large Hadron Collider (LHC) at CERN incorporates a hadronic calorimeter to register the energies of the charged and neutral hadrons produced in proton–proton collisions at the LHC at a center-of-mass energy of 13.6 TeV. This calorimeter is located inside a superconducting solenoid that is 6 m in diameter and 12.5 m in length, generating a central magnetic flux density of 3.8 T. For operating optimally in the high pileup and high radiation environment of the High-Luminosity LHC, the existing CMS endcap calorimeters will be replaced with a new high granularity calorimeter (HGCal) with an electromagnetic section and a hadronic section in each of the two endcaps. The hadronic section of the HGCal will include 44 stainless-steel absorber plates with a relative permeability value well below 1.05. The volume occupied by 22 plates in each endcap is about 21 m3. The calculation of the axial electromagnetic forces acting on the absorber plates is a crucial element in designing the mechanical construction of the device. With a three-dimensional computer model of the CMS magnet, the axial forces on each absorber plate were calculated, and the dependence of forces on the central magnetic flux density value is presented. The method of calculation and the obtained results are discussed.