沸腾
材料科学
多孔性
歧管(流体力学)
机械
机械工程
工艺工程
复合材料
工程类
热力学
物理
作者
Roman Giglio,Muhammad Shattique,Ercan M. Dede,Sreekant V. J. Narumanchi,Mehdi Asheghi,Kenneth E. Goodson,James W. Palko
标识
DOI:10.1016/j.applthermaleng.2024.124918
摘要
• Combination of a porous surface with a mesh manifold is tested in pool fed boiling. • Copper mesh separates and guides liquid and vapor flow above boiling surface. • Maximum heat flux of 490 W/cm 2 is dissipated at wall superheat of 36 °C in water. • Greater than 65% critical heat flux increase over porous surface alone. High-performance electronics are continuously demanding cooling of higher heat fluxes. Phase-change cooling, including pool boiling, is a useful approach to address this challenge; however, competition between liquid and vapor flows generally limit the heat fluxes that can be dissipated. A range of strategies to control these flows have been investigated previously, including capillary guides. Here a manifold structure formed from a metallic mesh is investigated to control the disposition of liquid and vapor phases above a pool fed boiling surface enhanced with porous structures. Copper mesh forms defined liquid flow paths, using capillary action to guide and distribute liquid evenly over the heated surface, along with open channels to facilitate vapor escape. The mesh provides a novel structure for liquid guidance that imposes low resistance to liquid flow while occluding a minimal area of heated surface underneath. The manifold performance is characterized in boiling fed by a pool of water above a laser-textured aluminum nitride heat dissipation surface with pin–fin structures having heights of 110 µm and spacing of 30 µm with a heated area of 5 mm x 5 mm. A maximum heat flux of 490 W / c m 2 is reached with the manifold in the pool fed configuration, representing an increase of more than 65% over the porous pin fin surface alone. The maximum stable superheat observed for the manifold of 36 K is 14 K higher than that for the porous surface without the manifold. The factors limiting performance of the manifold are analyzed. High superheat is attributed to partial flooding of the boiling surface as suggested by the reduction in superheat using external suction. Similar systems and structures for enhanced two-phase cooling are compared.
科研通智能强力驱动
Strongly Powered by AbleSci AI