Selective emitter structure leads to improve the solar cell efficiency by resolving the issue of trade-off between front doping and metallization. Laser doping is much attractive choice to fabricate selective emitter with simple additional step in low-cost at high through-put. The present work focuses on reduction of emitter leak current by laser doping using spin-on dopant source for textured n-type c-Si solar cells. Nd:YAG second harmonic wave laser (355 nm) was used for selective emitter formation. The surface dopant concentration measured by SIMS was increased by redistribution of boron atoms from boron rich layer (BRL) after additional laser doping. The surface texture formations after laser irradiation were almost completely preserved from smoothing, which was contributed by high adhesiveness and uniform coating of dopant source using poly-boron film (PBF®). The formation of selective emitter by laser doping contributed to reduction of reverse saturation current. The photovoltaic characteristics, Voc and F.F. were improved by formation of selective emitter. Consequently, these improvements of photovoltaic characteristics led to rising of solar cell efficiency about 3 %.