作者
Sherif Adekunle Tella,Abrar Alsheikh,Sanguo Li,Jibo Li,Guodong David Zhan
摘要
Abstract For many years, downhole data transfer has faced challenges due to limited communication bandwidths, resulting in delays in logging data acquisition and difficulties in capturing high-frequency drilling dynamics measurements. There is an urgent requirement to improve the capacity and speed of downhole data communication significantly. However, maintaining safe and optimal drilling conditions requires knowledge of downhole parameters. Hence, cost-effective drilling data microchips that collect real-time downhole data readings during drilling are necessary for precisely predicting wellbore property fluctuations, local overheating, and guiding the drilling trajectory in the wellbore. On the other hand, conventional alternative solutions use less than 10% of the acquired data in real time. Microchips often consist of an on-chip battery, sensors, secondary memory, and a system-on-a-chip (SoC). However, the data microchips may be exposed to random stresses throughout the drilling and releasing operations into the well annulus, which could lead to the failure of interconnects and other components, resulting in damage, loss of stored data, and a low recovery rate when the data microchips are released. This article reports one of the phases of a project and this phase describes the design and development of lab-qualified data microchips as a solution to high-resolution, near real-time, downhole data storage and transmission. The article also describes the results of field trials in five different well sections while drilling to evaluate and assess the physical recovery rate and integrity of data retention. A total of 134 lab-qualified data microchips (DM) were deployed in five well sections, achieving an overall physical recovery rate of 76.12% and a digital recovery rate of 89.22%. The third trial faced issues, recording the lowest physical recovery at 37.5%, yet had a perfect digital recovery. The 4th and 5th trials excelled, with recovery rates of 95.83% and 100%, respectively. A total of 11 DMs were damaged, which signifies that a considerable proportion of the deployed DMs were recovered successfully and most of them contained usable data. This report will present the design and development of data microchips considering the packaging, micromemory circuit, and communication protocol for data read/write. In addition, this report will discuss the testing methods, and the outcomes of the field trials conducted in five different well sections.