材料科学
薄膜
溅射
模式(计算机接口)
光电子学
铁电性
复合材料
溅射沉积
沉积(地质)
光学
作者
Tianqi Sun,Ian C. Graham,Marshall B. Frye,John A. Wellington-Johnson,Washat Ware,Kayla Y. Chuong,Lauren M. Garten
出处
期刊:IEEE open journal of ultrasonics, ferroelectrics, and frequency control
[Institute of Electrical and Electronics Engineers]
日期:2026-01-01
卷期号:: 1-1
标识
DOI:10.1109/ojuffc.2026.3738336
摘要
Unlike other ferroelectric materials, the critical limitation for AlScN is not operating temperature or CMOS integration, but rather the proximity of the ferroelectric coercive field (EC) to the breakdown field (EBD). The narrow EC-EBDmargin significantly reduces device reliability, necessitating the development of routes to reduce ECor enhance EBD. AlScN films deposited by different methods have been shown to exhibit different coercive fields, but a direct comparison and the underlying mechanisms are not yet established. This study investigates the impact of sputter deposition method - DC sputtering, RF sputtering, or simultaneous RF and DC co-sputtering - on the coercive field, permittivity, breakdown field, microstructure, and chemical state distribution of AlScN films. Al0.85Sc0.15N thin films were deposited from ceramic targets onto hafnium bottom electrodes at 400 °C. The ferroelectric response for each film type is determined from polarization-electric field (PE) hysteresis loops, polarization-up-negative-down (PUND) measurements, and Rayleigh analysis. RF sputtered films exhibit ferroelectric switching with an average PRof 63 μC/cm2and an average ECof 4.8 MV/cm, while DC sputtered films show only linear dielectric behavior. Co-sputtered films exhibit a range of ferroelectric and dielectric behavior, with clear separation between the coercive and breakdown fields. X-ray photoelectron spectroscopy (XPS) reveals that films deposited with increasing RF character exhibit higher Sc-O bond character corresponding with an increased breakdown strength. Thus, co-sputtering is promoted as a route to incorporate oxygen-rich insulating regions within the film, ultimately increasing the electrical breakdown strength of AlScN and enabling access to ferroelectric switching.
科研通智能强力驱动
Strongly Powered by AbleSci AI