Effect of Carbon Black on Dynamic Properties of Rubber Vulcanizates

Abstract The term dynamic properties as applied to elastomers refers to the response to periodic or transient forces which do not cause failure or appreciable fatigue (permanent change of properties) during the investigation. Generally this is limited to vulcanizates subjected to deformations not exceeding about 25%; and generally the dynamic properties are measured after several cycles or (in a transient experiment such as resilience) after several preconditioning transients, so that the Mullins effect or difference between first and second strain cycles is not of consequence. Thus, dynamic properties represent the viscoelastic properties of vulcanizates at deformations below about 25%, after reaching a pseudo-equilibrium state. The dynamic properties of rubber are altered tremendously by the addition of a filler. The scope of this article is restricted to the dynamic properties of rubber vulcanizates with carbon black as a filler. The effect covered in this article are important in designing rubber compounds to be used under dynamic conditions, such as tires, power transmission belts, vibration isolation mountings, etc . However, the engineering application of dynamic properties, which has been treated in detail elsewhere, is outside the scope of this review. A certain amount of background material is needed. We will first define the terms used in describing dynamic properties. The methods and instruments used for measuring these properties will be described briefly, and the nature of carbon black will be reviewed. Finally, some historical material is given, together with the dynamic behavior of typical compounds, as a preface to the review of more recent work in this field.