Microplastic particles are ubiquitously observed in the earth system, including in the air [1-2]. Although they are present at low concentrations in the air [3-4], they have long lifetimes and therefore their long-term evolution in the atmosphere needs to be understood. This study examines the absorption of ozone onto the surfaces of various model microplastics and analyzes changes in their physicochemical properties when exposed to ozone. Four different microplastics, low-density polyethylene (LDPE), polytetrafluoroethylene (PTFE), polyether ether ketone (PEEK), and polyethylene terephthalate (PET), were subjected to ozone concentrations between 500 and 7500 ppb for approximately 4 to 6 hours at atmospheric pressure and room temperature (295 K) using zero air as the carrier gas. Changes to the microplastics' surfaces were monitored in real-time using an optical cell integrated with a diffuse reflectance infrared Fourier transform spectrometer (DRIFTS), as shown in Figure 1. Figure 1. Schematic of the experimental set-up.These conditions are equivalent to roughly 1.5 to 25 days of atmospheric aging. The steady-state uptake coefficients determined. The uptake coefficients obtained, although low, are relevant for atmospheric conditions as microplastics persist for long periods in the atmosphere. The specific surface area of the microplastics was also measured before and after exposure, using the Brunauer–Emmett–Teller (BET) method. The modifications observed influence on the lifetime of the particles and can change the interaction of microplastics with various volatile organic compounds (VOCs) and water. [1]Dris, R. et al. Environmental Pollution 221, 453–458, 2017.[2]Allen, S. et al. Nat Commun 12, 7242 (2021).[3]Dris, R. et al. Environ. Chem. 12, 592–599 (2015).[4]O’Brien, S. et al. Science of The Total Environment 874, 162193 (2023).