Improved Short-Circuit Current and Fill Factor in PM6:Y6 Organic Solar Cells through D18-Cl Doping

Based on the PM6:Y6 binary system, a novel non-fullerene acceptor material, D18-Cl, was doped into the PM6:Y6 blend to fabricate the active layer. The effects of different doping ratios of D18-Cl on organic solar cells were investigated. The best-performing organic solar cell was achieved when the doping ratio of D18-Cl reached 20 wt%. It exhibited a short-circuit current of 28.13 mA/cm2, a fill factor of 70.25%, an open-circuit voltage (Voc) of 0.81 V, and a power conversion efficiency of 16.08%. The introduction of an appropriate amount of D18-Cl expanded the absorption spectrum of the active layer, improved the morphology of the active layer, reduced large molecular aggregation and defects, minimized bimolecular recombination, and optimized the collection efficiency of charge carriers. These results indicate the critical importance of selecting an appropriate third component in binary systems and optimizing the doping ratio to enhance the performance of ternary organic solar cells.