残余应力
材料科学
铝
合金
表面粗糙度
冶金
焊接
搅拌摩擦焊
表面光洁度
复合材料
作者
Magdalena Bucior,R. Kluz,Andrzej Kubit,Kamil Ochał
标识
DOI:10.12913/22998624/156943
摘要
This article presents the influence of the brushing process on residual stress and surface roughness of EN AW-2024-T3 aluminum alloy joints welded using the Friction Stir Welding (FSW) method. Butt joints with thicknesses of 2 mm were brushing with using ceramic brush. The aim of the study was to find optimal parameters of the brushing process, which would significantly improve the functional properties of welded joints. The experiments were carried out in two steps. In the first stage of the research, the feed rate was changed in the range f = 40 ÷ 120 mm / min with a constant brushing depth d = 0.5 mm. The roughness decreased from Sa = 5.285 µm for the specimen after welding to Sa = 2.460 µm for the f = 120 mm/min and d = 0.5 mm. The change in the parameters of the brushing process did not have a significant impact on the state of residual stresses. Hence, in the second step, the brushing depth was increased in steps of 0.1 mm. The best properties were obtained for f = 120 mm / min and d = 0.6 mm (variant 6A), where roughness was Sa = 0.443 µm and compressive stresses σ = -118 MPa.
科研通智能强力驱动
Strongly Powered by AbleSci AI